Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Waco?
A chimney liner installation in Waco typically costs $2,400 to $6,800 for a standard single-flue home, and a partial chimney rebuild runs $3,200 to $9,500 depending on how much brickwork has to come down and go back up. A full top-to-bottom rebuild of a masonry chimney generally lands between $9,000 and $22,000. Relining is the more common job here by a wide margin, because most Waco chimneys were built with clay tile flues that crack, spall, or separate at the joints long before the brick itself fails.
Those ranges cover the work most homeowners actually need: a stainless liner sized to the appliance, insulation, a top plate and cap, and the labor to get it in. The written estimate sets the final price, and every estimate we give is free.
What’s Included in the Estimate
Every quote we write for a Waco homeowner breaks the job into the parts that drive the number, so you can see where the money goes instead of staring at one lump figure. A typical reline estimate itemizes the liner itself, insulation, the top plate and cap, any flue prep or resurfacing, and the labor to remove the old liner if one has to come out. A rebuild estimate itemizes demolition, masonry and mortar, any crown or flashing work, and a new liner if the old one can’t be saved.
We work with professional-grade product lines rather than big-box substitutes. That means DuraFlex for liner systems, HeatShield for flue resurfacing and ceramic repair, Copperfield and Olympia Chimney supply lines for liners and components, and Gelco and Famco for caps, covers, and venting parts. Those are the same sources full-time chimney contractors across the country buy from. Trade-level products installed by people who know how they work is the standard we hold on every job.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s how the work breaks down by line item for the Waco market in 2026. These are typical estimates, not quotes, and the written estimate you receive is what sets your actual price.
| Work | Typical Waco Range | What It Covers |
|---|---|---|
| Standard stainless reline (single flue) | $2,400 – $4,900 | Insulated stainless liner sized to the appliance, top plate, cap, and labor |
| Oversized or two-story reline | $4,200 – $6,800 | Longer runs, larger flue, or a liner that has to be fabricated to fit |
| HeatShield flue resurfacing | $1,600 – $3,900 | Ceramic resurfacing of a damaged clay flue so it can stay in service |
| Chimney crown rebuild | $900 – $2,600 | Removing a cracked crown, reforming the slope, and sealing the top |
| Partial rebuild (upper section) | $3,200 – $7,400 | Tearing down and rebuilding the failed portion of the stack |
| Full chimney rebuild | $9,000 – $22,000 | Full teardown and rebuild, new liner, crown, and flashing |
| New cap and top plate | $280 – $750 | Gelco or Famco cap sized to the flue, plus a sealed top plate |
| Flue tile repair (spot) | $450 – $1,400 | Replacing separated or cracked tiles in an otherwise sound flue |
What pushes a Waco liner or rebuild toward the top of these ranges is almost always access and condition. A chimney on a steep roof, a flue that’s been relined badly before, or a stack that’s pulling away from the house all add labor. What keeps a job at the low end is a straight flue run, a sound crown, and a chimney that only needs the liner and nothing else. We’ll tell you exactly what your chimney needs and why before any work starts.
What Affects Chimney Liner & Rebuild Pricing in Waco
- Flue size and shape. A round flue takes a standard liner easily. An oval or rectangular clay flue, which is common in older Waco homes, often needs an ovalized liner or a custom fit, and that adds cost.
- Appliance type. A wood-burning fireplace insert or a wood stove needs a liner sized to its flue collar and a proper connection. A gas appliance draws a different liner specification. Getting the sizing right the first time is what keeps the liner working and keeps you out of a second repair.
- Height and roof pitch. A chimney on a single-story ranch with a low pitch is a straightforward job. A two-story home or a steep roof means more staging, more time, and more labor in the number.
- Condition of the clay tile. If the original clay liner is cracked or the joints have opened, the old liner has to come out or be resurfaced before a new one goes in. HeatShield resurfacing is often the smarter call than demolition when the tile is still structurally sound.
- Water damage and the crown. Central Texas heat and summer storms take a toll on masonry crowns. A crown that’s cracked lets water into the stack, and that water is what eventually forces a rebuild instead of a reline. Catching the crown early is the cheapest repair on this page.
- Brick and mortar condition. Spalling brick, eroded mortar joints, and a chimney that’s leaning all shift a job from reline territory into rebuild territory. The difference between the two is the single biggest swing in the whole estimate.
Why Relining Is More Common Than Rebuilding in Waco
Most of the chimneys we look at around here were built decades ago with clay tile flues. Clay tile works fine when it’s intact, but it cracks, the joints separate, and mortar washes out over time. Once that happens, the flue no longer contains the smoke and gases the way it should, and the fix is almost always a stainless liner rather than tearing the chimney down.
A DuraFlex liner system, insulated and sized to the appliance, gives you a continuous flue inside the old one. It’s a full relining job, not a cosmetic patch, and it’s what we install when the existing flue can’t be trusted. When the tile is still sound but the surface is rough, HeatShield ceramic resurfacing can restore it and extend the chimney’s life without a full replacement. That capability is worth asking about, because it’s a repair depth that sweep-only outfits don’t offer.
Waco sits in a part of Texas where summers run long and hot and the occasional hard freeze does come through. That swing is hard on masonry. A crown that holds up and a liner that’s properly sealed are what keep a chimney from turning a small repair into a large one.
When a Rebuild Beats a Reline
A rebuild is the right call when the brickwork itself has failed, when the chimney is pulling away from the house, or when the stack has deteriorated to the point that a new liner has nothing sound to sit inside. We don’t recommend a rebuild if a reline and a crown repair will do the job. That’s the whole point of a proper inspection: to find out which one you actually need before anyone starts swinging a hammer.
Our inspection service is built to document what’s there, not to sell you a rebuild. If you need the report for insurance, we’ll put the findings in writing with photos. If you just want to know whether your chimney is safe to use this season, the inspection answers that too. Sweep, repair, and inspect are handled by one specialist, so you’re not coordinating three contractors to get one chimney sorted out.
How to Save on Chimney Liner & Rebuild in Waco
- Fix the crown before it costs you a rebuild. A crown repair in the hundreds is the least expensive work on this page. Waiting until water has worked into the stack turns it into a four-figure rebuild.
- Ask about resurfacing before demolition. If the clay tile is sound but rough, HeatShield resurfacing may save the flue without a full reline. It’s worth asking about specifically.
- Bundle the liner and the cap. If the liner is going in anyway, a properly fitted Gelco or Famco cap protects the whole system between visits and keeps rain and animals out.
- Get the inspection first. You can’t price a repair you haven’t diagnosed. An inspection tells you whether you’re looking at a reline, a resurface, or a rebuild before any numbers get thrown around.
- Get a free estimate in writing. The price is set per job by the written estimate, and ours doesn’t cost you anything. Call (866) 370-3896 and we’ll schedule a look.
What Happens When You Call
We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. Same-day service is often possible depending on the schedule. When a technician arrives, the first step is a look at the flue, the crown, and the masonry. From there you get a written estimate that itemizes the work and tells you plainly whether you’re looking at a reline, a resurface, or a rebuild.
Our technicians have up to experience, and the products we install are the same professional-grade lines full-time chimney contractors rely on. We’ll tell you exactly what your chimney needs and why, and we won’t recommend a rebuild where a reline will do.
FAQs – Chimney Liner & Rebuild Cost
How much does a chimney liner cost in Waco?
A chimney liner in Waco typically costs $2,400 to $6,800, with most standard single-flue homes landing between $2,400 and $4,900. Larger flues, two-story runs, and oval or rectangular flues that need a custom-fit liner push toward the higher end. Call (866) 370-3896 for an exact quote. Estimates are free.
Is it cheaper to reline a chimney or rebuild it?
Relining is almost always cheaper than a rebuild. A reline runs $2,400 to $6,800, while a full rebuild starts around $9,000 and can reach $22,000. The right question is whether your brickwork is sound enough to reline. If it is, relining is the answer. Call (866) 370-3896 and we’ll tell you which one your chimney needs.
Do I need a permit to reline or rebuild a chimney in Waco?
Most cities require a permit for structural chimney work, and rules vary by jurisdiction, so check with the City of Waco’s building department before work starts. Relining and rebuilds both typically fall under that umbrella. We’ll walk through what applies to your job when we give the estimate. Call (866) 370-3896 to schedule it.
Can you reline my chimney the same day?
Same-day relining is often possible when the flue is accessible and the liner is on hand, though a standard job usually runs a full day or more depending on height and access. Rebuilds take much longer, often several days. Call (866) 370-3896 and we’ll give you a realistic timeline with the estimate. We answer 24/7.
How long does a chimney liner last?
A properly installed stainless liner should serve for decades, and the exact life depends on the appliance, the fuel, and whether the cap and crown are keeping water out. The liner itself isn’t the weak point. The crown and cap are. Call (866) 370-3896 to find out what condition yours is in.
Get a Free Estimate on Your Waco Chimney
Every chimney is a little different, and the only way to know whether you’re looking at a reline or a rebuild is to have someone who knows chimney systems look at it. We do all three from one company: sweep, repair, and inspect. You get straight answers, professional-grade materials, and a written estimate that tells you what the work is and what it costs. For the local side of the service, see our chimney sweep Waco page.
Call (866) 370-3896 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday.
Pricing reflects the Waco market as of 2026. Chimney Sweep Waco offers free estimates – call (866) 370-3896.
Written by the team at Chimney Sweep Waco.
What Our Customers Say
"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
- Neil Vaughn"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
- Daniela Salazar"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Lamont Nash